Horizon Fitness T30 - Manual

U N P A C K I N G
Take caution when handling and transporting this unit. Never
open box when it is on its side. Once the banding straps have
been removed, do not lift or transport this unit unless it is fully
assembled and in the upright folded position, with the lock
latch secure. Unpack the unit where it will be used. The
enclosed treadmill is equipped with high-pressure shocks and
may spring open if mishandled. See owner’s guide for refer-
ence. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN INJURY! Place your treadmill on a level flat sur-
face. It is recommended that you place a protective covering
on your floor.
H O R I Z O N F I T N E S S C U S T O M E R A S S I S T A N C E C E N T E R 1 . 8 0 0 . 2 4 4 . 4 1 9 2 o r w w w. h o r i z o n f i t n e s s . c o m
NOTE: It is recommended that you apply grease
to the threads of each bolt as you assemble your
treadmill, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
A) 60mm Bolt
Quantity: 2
E) 20mm Bolt
Quantity: 4
= Tighten
C) 13mm Nut
Quantity: 2
B) 16mm Washer
Quantity: 2
D) Arc Washer
Quantity: 2
Parts
• 1 Power Cord
• 1 Safety Key
• 2 Water Bottle Holders
• 1 Hardware Pack (contents listed below)
Tools (included)
• 5mm Allen Wrench/Phillips Screw Driver
• Flat Wrench
• 8mm Allen Wrench
or
• 6mm Allen Wrench
H A R D W A R E
1
3
2
4
A
E
D
C
B
C
B
E
E
E
A
D
A S S E M B L Y
G U I D E
HORIZON T30 & T40
1. LIFT CONSOLE MAST INTO
UPRIGHT POSITION. 2. SET CONSOLE INTO PLACE.
3. TIGHTEN PRE-INSTALLED BOLTS.
SAFETY KEY
horizon t30 t40.qxd 11/11/2003 11:03 AM Page 1