Hayter Mowers RZT420H - Manual (Page 13)

4
Completing the Setup
Parts needed for this procedure:
1 Ignition Key
1 Operator’s Manual
1 Engine Operator’s Manual
Procedure
Checking the Tyre Pressure
Check the front and rear tyres for proper inflation. Refer
to Checking the Tyre Pressure in the Operator’s Manual
for the recommended inflation pressure.
Checking the Side Discharge Chute
Remove the packing restraint holding the side discharge
chute up and lower the chute into place.
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
the Oil Level in the Operator’s Manual.
Checking the Cutter Deck Adjustment
The cutter deck was leveled at the factory. If the cutter
deck is not cutting level, adjust the side-to-side level and
the front-to-rear blade slope. See the Operator’s Manual
for the proper procedure.
Review the Remaining Parts
Keep all the following items with the machine:
• Ignition Key
• Operator’s Manual
• Engine Operator’s Manual
13