HP LaserJet 1320nw Wireless User Manual
Page 34
28 Chapter 3
Problem solving
ENWW
7
Select OK.
8
Open the configuration utility for your wireless network adapter.
9
Write down the existing wireless profile settings.
10 Create a new wireless profile with the following values:
• Communication mode: Ad Hoc
• Network name (SSID): hpsetup
• Encryption: disabled
(This is the default configuration for your printer’s internal networking component.)
11 Activate the profile.
When the configuration change is complete, the computer is ready to communicate on the
printer’s network. (The computer is no longer part of its original network.)
Note
Unless you change your computer settings, the computer will continue to communicate with your
existing wireless network. However, the wireless device that you need to configure is on its own
network (called hpsetup). To configure that device, you need to temporarily change your computer
to the printer’s network.
12 Print a network configuration page and obtain the IP address of the printer.
To print a configuration page, when the printer is in the Ready state, press and hold the Go
button for 5 seconds. For more information, see
13 Open your Web browser on your computer.
14 Type either the URL or device IP address from the network configuration page into the
Address field in your browser. The EWS Home page appears.
15 Select the Networking tab.
16 From the Network Settings page, select the Wireless tab.
17 Scroll to the appropriate section and enter the profile values you recorded in step 9.
18 Click Apply.
19 Exit the EWS by closing your browser.
20 Open the configuration utility for your wireless network adapter.
21 Restore the previous wireless profile settings.
22 Wait 60 seconds and then print a network configuration page. The Wireless light should be on.
23 Open your Web browser on your computer.
24 Enter either the URL or device IP address from the network configuration page into the
Address field in your browser. If the EWS Home page appears, your printer is properly
configured.
25 Exit the EWS by closing your browser.
26 Insert the printer software installation CD into your computer's CD-ROM drive.
27 Run the installation software again.