HP LaserJet 1320nw Wireless - Manual (Page 15)

ENWW Network configuration page 9
Network configuration page
The printer includes an internal component that provides networking capability for both wired and
wireless connectivity. This section contains a procedure for printing a network configuration page,
as well as a description of the general network and wireless network fields that display on the
page.
Printing a network configuration page
When the printer is in the Ready state, press and hold the Go button for 5 seconds.
or
Press the Reset button on the back of the printer.
General and wireless network settings
Note All of the settings on the network configuration page should match the settings of the network with
which you are trying to connect. If any values are different, you might not be able to connect to the
network.
The following sections describe the various fields on the network configuration page.
General network settings
Field Description
Status Status of the printer:
● Initializing: the network is initializing.
● Ready: the device is ready to receive or transmit data.
Network
Connection Type Network mode of the printer:
● Wired: the printer is connected by Ethernet cable to an
IEEE 802.3 network
● Wireless printer can connect wirelessly to 802.11b or
802.11g
● Disabled: Both network connection types are disabled.
Note Only one connection type can be active at
a time.
Hardware Address The Media Access Control (MAC) address that uniquely
identifies the printer. This is a unique 12-digit identification
number assigned to networking hardware for identification, like
a digital fingerprint. No two pieces of hardware have the same
MAC address.
Note Some ISPs require that you register the
MAC address of the Network Card or LAN
Adapter that was connected to your cable
or DSL modem during installation.