Hoover Carpet Cleaner - Manual (Page 6)

6
1-14
1-10 1-11
Press cord into cord clip on back of
hose holder. Pull cord tight.
Storing hose
Stretch hose out and identify ends.
E. Nozzle connector end of hose
G. Solution tube
F. Trigger H. Converter end of hose
Note: You may find it helpful when storing the hose to refer to the informa-
tion on the back of the carpet cleaner and on the converter end of the
hose.
Start with converter end of hose (H).
Fit converter over tab near tool hold-
er (I). Press converter firmly to snap
in place. Press solution tube (G) into
clip next to converter as shown.
Wrap hose around hook on upper
handle (J). Press hose into clips on
upper hose holder (K).
G
H
H I
J
K
G
K
F
E
1-12 1-13
Wrap hose around lower tool holder
and continue until nozzle connector
is near upper hose holder. Clip hose
in place.
How to reattach tool
cover
The tool cover is designed with a
break-away feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges of cover
with slots on sides of tool storage
area.
Push cover down to secure in place.
1-15 1-16
Stair/upholstery nozzle
To store stair/upholstery nozzle,
open tool door, place nozzle in
bracket and fit it securely into posi-
tion. To remove, reverse this proce-
dure.
Upfront tool storage