HP 3C590-TPO - Manual (Page 12)

3 Connecting to a Windows NT Server 3.51
Windows for Workgroups Ver. 3.11
7 After windows loads, open the “NETWORK” Program Group, and double-
click on “Network Setup.”
8 Select the “Networks” button in the “Network Setup” dialog box.
9 Click on the “Install Microsoft Windows Network:” option, and click “OK.”
10 Click on the “Drivers” button from the “Network Setup” dialog box, and
click on “Add Adapter”.
11 Click “OK” to accept the default choice of “Unlisted or Updated Network
Adapter.”
12 Type the path “A:\WFW311” in the “Install Driver” dialog box, and then
insert the 3COM 3C509 drivers disk into the floppy drive, and click “OK.”
(If you have an HP preloaded HDD, set path to
“C:\LANDRV\3C509B\WFW311”)
13 Select “3Com Etherlink III (3C5X9)” in the “Unlisted or Updated Network
Adapter” dialog box, and click “OK.”
14 Make sure that the “3Com Etherlink III (3C5X9) [NDIS2/NDIS3]” is
selected in “Network Drivers.”
15 Accept the applicable network protocols, and then click on “CLOSE.”
3Com EtherLink III (3C5X9) (NDIS2/NDIS3 )
Microsoft NetBEUI
IPX/SPX Compatible Transport with NetBIOS
(If you do not have the required information, contact your network
administrator)
16 At the “Network Setup” dialog box, click on “OK”.
17 Specify your User Name, Workgroup, and Computer Name in “Microsoft
Windows Network Names” dialog box, and click on “OK”. (The Drivers
will now start to copy)
18 Finish the network card installation by clicking on “OK” in the “Network
Setup” message.
19 To complete the installation, click on “Restart Computer” button in the
“Windows Setup” dialog box.