beautypg.com

Quickspecs, Step 1: base server blade configuration – HP Integrity server blade BL860c User Manual

Page 22

background image

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid
configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on CTO product offerings and requirements.
NOTE: This product offering does not support HP Factory Express Server Configuration Level 1.
NOTE: HP does not allow factory integration of options into standard models listed above.
Configure-to-order servers must start with a CTO Chassis.
NOTE: FIO indicates that this option is a Factory Installable Option.

Step 1: Base Server Blade Configuration

Models

HP Integrity BL860c Server Blade

NOTE: Choose from base models above.
NOTE: Adding Option code "#0D1" to the Server Blade PN will integrate the
configured blade into the enclosure (which must be on the same order)

Configurable Model ships with:

Four embedded Gigabit Ethernet NIC ports plus (1) additional 10/100 NIC
dedicated to Integrity iLO 2 Management

Integrated LSI 1068 hardware RAID controller

Two small form factor (SFF) SAS hot plug hard drive bays

HP Integrity Integrated Lights-Out 2 Advanced Pack

Step 2: Choose Required Options (one of the following from each list unless
otherwise noted):

Processors

Select a base model (either 2P or 1P models) which has the desired CPU
offering.

Memory

HP 2GB PC4200 DDR-SDRAM(2x1GB DIMMs)

AD343A

HP 4GB PC4200 DDR-SDRAM(2x2GB DIMMs)

AD344A

HP 8GB PC4200 DDR-SDRAM(2x4GB DIMMs)

AD345A

NOTE: Memory Modules consist of pairs of DIMMs

NOTE: DIMMs must be installed in pairs

RAID 1 Configuration
Upgrade Option

Factory configured hardware RAID 1

AD248A#106

NOTE: Requires two (2) SAS Hard Drives identical in speed and capacity
NOTE: Ordering AD242A#106 provides factory configuration of the embedded
LSI 1068 SAS controller to RAID1.

QuickSpecs

HP Integrity BL860c Server Blade

Configuration Information - Factory Integrated Models

DA - 12671 U.S. QuickSpecs — Version 18 — 2/18/2009

Page 22