beautypg.com

Fig. 4 fig. 3 – Hoshizaki KMH-2000SWH/3 User Manual

Page 13

background image

13

5) Install the bin control thermostat as follows:

a. Remove the baffle from the bin (if applicable).
b. Remove the tie securing the bin control thermostat assembly. Remove the

2 thumbscrews and the "Z" bracket. See Fig. 3.

c. Remove the bin control thermostat assembly from the shipping hook. Lower the

thermostat extension bracket (stainless) with the thermostat bulb attachment and
thermostat bulb through the hole located at the bottom of the icemaker. Next, lower
the thermostat bracket (plastic) through the hole.

d. Slide the left side of the upper part of the assembly towards you and make sure it

is hooked on the wall. Make sure the left side and bottom of the assembly are flush
against the wall and base panel.

e. Secure the assembly in place with the thumbscrews (unless you are installing an

upper unit).

f. Insert the plug into the receptacle on the assembly until it locks into place.

Note: Icemaker will not run if the plug is not in the receptacle.

g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the

thermostat extension bracket (stainless). See Fig. 4. Use the 2 screws to attach the
"Z" bracket (plastic) to the thermostat extension bracket (stainless).

h. Use the two 4×10 stainless steel screws

in the accessory bag to attach the
thermostat bulb attachment (with attached
thermostat bulb) to the "Z" bracket.

i. Remove the 2 screws from the lower

part of the thermostat bracket (plastic)
and use them to attach the thermostat
extension bracket (stainless) to the
thermostat bracket (plastic).

j. Make sure the silicone hose is in place

to prevent ice from striking the capillary
tube.

Fig. 4

Fig. 3

Bin Control

Thermostat

Assembly

Shipping Hook

Thermostat Bracket

(plastic)

Tie

"Z" Bracket

Thermostat Bulb
Attachment (plastic)
and Thermostat Bulb

Thumbscrews

Thermostat Extension

Bracket (stainless)

Hole

Plug

Receptacle

Thumbscrews

Hook

Bushing

Thermostat Bracket
(plastic)

Thermostat Bulb
Attachment (plastic)

"Z" Bracket (plastic)

Thermostat Extension
Bracket (stainless)

Silicone Hose

This manual is related to the following products: