HP 958-000290-000 - Manual (Page 27)

edge switch 2/32 installation guide 2-1
2
Installing and Configuring
the Edge Switch 2/32
This chapter describes tasks to install, configure, and verify operation of the edge
switch 2/32. The switch can be installed on a table or desk top, or mounted in any
standard equipment rack.
For a list of the factory-set defaults for the switch and the Reset Configuration option,
refer to
Appendix B .
Summary of Installation Tasks
Table 2–1 summarizes installation tasks for the switch, HAFM server, and Ethernet
hub. The table numbers and describes each task, states if the task is required or
optional, and lists the page reference for the task. If a task is optional, decision-related
information is included.
Table 2–1: Installation Task Summary
Task Number and Description Required or Optional Page
Task 1: Verify Installation Requirements Required 2–3
Task 2: Unpack, Inspect, and Install the
Switch Required 2–4
Task 3: Configure Network Information Optional—configure if connecting
multiple switches or if connecting a
switch and
HAFM server to a public
LAN.
2–6
Task 4: LAN-Connect the Switch Required 2–11
Task 5: HAFM Server (Optional) Optional—if not done, then the switch
should be configured using the
Embedded Web Server (EWS)
interface. 2–12