HP 958-000290-000 - Manual (Page 142)

Index–4 edge switch 2/32 installation guide
Index
port binding 2–35
port blocked states, default value B–2
port, cabling 2–69
ports
binding 2–35
default values B–2
UDP, default value B–3
power supplies 1–7
LEDs 1–9
power supply requirements B–4
preferred domain ID 2–27
multiswitch fabric 2–26 , 2–30
preferred domain ID, default value B–2
principal switch, determining 2–31
product manager
configuring 2–23
configuring e-mail notification 2–40
configuring SNMP trap message recipients
2–39
configuring switch identification 2–24
R
R_A_TOV
default value B–2
r_a_tov 2–31
greater than e_d_tov 2–31
rack stability, warning xii
Regulatory Compliance identification numbers
A–1
regulatory compliance notices A–1
remote notification, testing 2–50
remote offline control states, default value B–3
rerouting delay 2–27
routing delay, default value B–2
S
S/390 mode 2–28
FICON management server 2–28
serviceability features 1–3
SFP transceivers 1–7
LEDs 1–9
longwave 1–7
shortwave 1–7
SNMP
configuring trap message recipients, EWS
2–65
configuring trap recipients, product manager
2–39
default values B–3
introduction 1–4
SNMP authorization trap states, default value
B–3
SNMP communities, default value B–3
SNMP write authorizations, default value B–3
software
diagnostic features 1–9
speeds, director, default B–2
subnet mask
configuring 2–6
default B–1
subnet mask, default value B–2
Summary of Installation Tasks 2–1
switch
connecting to fabric director 2–69
connectors and indicators 1–8
error-detection, reporting, and serviceability
features 1–3
fans 1–7
FRUs 1–6
LAN connecting 2–11
LEDs 1–9
maintenance port 1–9
management 1–5
multiswitch fabric 1–5
network addresses 2–6
power supplies 1–7
setting date and time 2–21
SFP transceivers 1–7
unpacking, inspecting, and installing 2–4
verifying communication to HAFM server
2–14
switch parameters
domain RSCNs 2–28
insistent domain ID 2–27
NV-RAM storage 2–25 , 2–29