HP 100TX NightDIRECTOR/100 - Manual (Page 14)

1 Installing the HP LAN Card
Pre-installation Procedure
6 English
Pre-installation Procedure
CAUTION Perform the pre-installation before you physically install the HP LAN
card in the PC.
Pre-installation on a Windows 95 System
1 With Windows 95 running, insert the HP LAN Setup diskette into the
diskette drive.
2 Click Start, and then Run.... The Run dialog box opens.
3 In the command line, type a:\setup and click OK. A network
setup dialog box opens.
4 Click Next. A second network setup dialog box opens.
5 Click Finish. The PC reboots under DOS and displays a message
asking you whether there is another LAN card already installed.
6 Type n , then remove the HP LAN Setup diskette from the diskette
drive and turn off the PC.
7 Now go to “Installing the HP LAN Card” on page 8.
Pre-installation on a Windows NT 4.0 System
1 With Windows NT running, insert the HP LAN Setup diskette into
the diskette drive.
2 Click Start, then Run....
3 In the command line, type a:\setup and click OK. An account
information dialog box opens.
4 Enter the name of an account which is a member of the
administrator group, and the corresponding password. If you are
already logged on with administrator’s rights, the field for the
account name is automatically filled in with your account name.
5 Click Next. A dialog box is displayed.
book.bk : chapter.fb Page 6 Monday, October 13, 1997 6:08 PM