HP PROLIANT DL180 - Manual (Page 52)

HP 160GB 3G SATA
7.2K rpm LFF (3.5-inch)
Entry 1yr Warranty
Hard Drive
458945-B21 160GB 7,200 rpm Capacity 160,041MB
Height 1.04 in (26.4 mm)
Width 4.36 in (110.7 mm)
Depth 7.25 in (184.2 mm)
Interface Serial ATA
Transfer Rate
(Maximum) 3Gb/s
Native Command
Queuing Supported
Seek Time
(typical reads, including
settling) Single Track 2.0 ms
Average <11 ms
Full-Stroke 23.0 ms
Rotational Speed 7,200 rpm
Physical Configuration Bytes/Sector 512
Logical Blocks 312,581,808
Operating Temperature41° to 131° F (5° to 55° C)
Smart Array P212
Controller Disk Drive and
Enclosure Interface 3G SAS (Serial Attached SCSI)
1.5G SATA (Serial ATA)
SAS Connectors 1 internal/1 external (Mini-SAS) x8 wide port connectors
Cache Memory Speed DDR-2/533 MHz with 40 or 72-bit wide bus provides up to 4.2 GB/s
maximum bandwidth.
Server Interface x8 2.5G PCIe 2.0 provides 2GB/s maximum bandwidth.
SAS Speed x8 3G SAS provides 2.4GB/s maximum bandwidth.
Cache Memory 40-bit 256MB ECC protected cache; transportable with battery-backed
upgrade.
NOTE: The 256MB cache is not battery-backed or transportable.
Logical Drives
Supported Up to 32 logical volumes
Host Memory
Addressing 64-bit, supporting greater than 4GB server memory space
RAID Support RAID 6, 6+0 (Advanced Data Guarding)
NOTE: A minimum of 256 MB cache, battery kit, and Smart Array
Advanced Pack License Key upgrade is required to enable RAID 6, 6+0
RAID 5, 5+0 (Distributed Data Guarding)
NOTE: The 256 MB & Battery Kit upgrade is required to enable RAID 5,
5+0 support
RAID 1, 1+0 (Striping & Mirroring)
RAID 0 (Striping)
QuickSpecs
HP ProLiant DL180 Generation 6
Technical Specifications
DA - 13248 Worldwide QuickSpecs — Version 22 — 7/13/2010 Page 52