Pressure roller removal (continued) – HP 1100AHP User Manual

Page 102

Text mode
Original mode

100 Removal and Replacement

C4224-90962

Pressure roller removal (continued)

Figure 4-37

Removing the pressure roller

CAUTION:

This Pressure Roller is covered with light contact grease. Do not get it on your clothes. See
Chapter 6, “Parts and diagrams,” for information about ordering pressure roller grease.

NOTE:

The half bushing on the right of the assembly or the full bushing on the left end of the assembly
are not connected to the printer chassis and may come loose during removal.

Loosen the two screws in the fusing guide (see callouts).

Lift the right end of the Pressure Roller out of the half bushing and slowly move the roller
to the right, pulling the left end of the roller axle out of the opening on the left side of the
printer.