Honeywell 2020 - Manual (Page 133)

8 - 3
Resetting the Standard Product Default Settings:
All Application Work Groups
The following barcode defaults all of the work groups to the factory settings.
The Menu Commands starting on page 10-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
Temporary Visual Xpress Configuration
For quick download communication configuration, scan the Visual Xpress bar-
code to temporarily configure the imager for Visual Xpress settings. Refer to
Visual Xpress on page 9-1 for additional information about Visual Xpress.
Note: Connect the imager using RS-232 cables. Scan the barcode below and
the unit will communicate in RS-232 mode, allowing it to work with Visual
Xpress. The imager reverts to the original or reprogrammed interface
when the power is cycled.
Note: If you download new software into a unit, the user-programmed
parameters are retained. If you need to discard user-programmed
settings, scan the Standard Product Default Settings barcode (see
Resetting the Standard Product Default Settings: Current Application
Work Group
on page 8-2).
Standard Product Default Settings:
All Application Groups
Visual Xpress