Terminal interfaces, Terminal id, Chapter 2 - terminal interfaces – Hand Held Products 5620 User Manual

Page 39: Terminal id -1

2 - 1

Terminal Interfaces

Terminal ID

If your interface is not a standard PC AT, refer to

, and locate the Terminal ID number for your PC. Scan the

Terminal ID bar code below, then scan the numeric bar code(s) from the

inside the back cover of this manual to program the scanner

for your terminal ID. Scan Save to save your selection.

For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the

cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the

, scan

the Terminal ID bar code, scan the digits, and the Save code again.

Note: The default interface for the IT2020-5 is Keyboard Wedge (Term ID =

003).

Note: After scanning one of these codes, you must power cycle your computer.

Terminal ID

Save