HONDA Outboard Motor BF75A - Manual (Page 93)

91
Propeller Replacement
SERVICING YOUR OUTBOARD MOTOR
PROPELLER
COTTER PIN
THRUST WASHER
PLAIN WASHER
CASTLE NUT
Removal Installation
Install the thrust washer with the
grooved side toward the gear case.
Use a genuine Honda cotter pin
and bend the pin ends as shown.
Before replacing the propeller,
remove the clip from the engine stop
switch to prevent any possibility of
the engine being started while you
are working with the propeller.
The propeller blades may have sharp
edges, so wear heavy gloves to
protect your hands.
Remove the cotter pin, unscrew the
castle nut, remove the washer, then
remove the propeller and thrust
washer. Install the propeller in the reverse
order of removal. 1.
02/03/25 21:32:42 31ZW0601_092