HP Server Blades BL30p - Manual (Page 21)

NOTE: HP does not allow factory integration of options into standard models listed above.
Configure-to-order servers must start with a CTO Chassis.
Step 1: Base Server Blade Configuration
Model HP ProLiant BL30p Configurable Model 367243-405
Configurable Model ships with:
- Two embedded NC7781 PCI-X Gigabit NICs plus one 10/100T NIC for iLO
- Integrated Lights-Out (iLO) Management with Advanced Pack features
Step 2: Choose Required Options (only one of the following from each list unless otherwise
noted)
Processor For single processor configuration choose:
Xeon 3.06GHz/533-512 FIO Base 354053-L21
For dual-processor configurations choose two each of:
Xeon 3.06GHz/533-512 FIO Base 354053-L21
Xeon 3.2GHz/533-1M FIO 368273-B21
Xeon 3.2GHz/533-2MXeon 3.2GHz/533-2M FIO 364306-B21
NOTE: Dual-processor configurations must have a matching pair of CPUs. Mixed clock speeds
are not supported.
Memory NOTE: Two-way interleaving memory is enabled when an identical pair of DIMMs is installed.
For 1GB Total Memory choose A or B:
A) 2 x 512 MB PC2100 DDR SDRAM DIMMs 300679-B21
B) 1 x 1GB PC2100 DDR SDRAM DIMM 287497-L21
For 2GB Total Memory both A and B are required:
A) 1 x 1GB PC2100 DDR SDRAM DIMM 287497-L21
B) 1 x 1GB PC2100 DDR SDRAM DIMM 287497-B21
For 4GB Total Memory:
2 x 2048MB PC2100 DDR SDRAM DIMM 2x2048 300682-B21
Step 3: Choose Additional Options for Factory Integration
Hard Drive 60GB Small Form Factor ATA Hard Drive, 5400 rpm 354052-B21
Fibre Channel Option BL30p Dual Port Fibre Channel Adapter 354054-B21
NOTE: For additional options, including BL30p blade sleeve, server blade enclosure with
enhanced backplanes, interconnect options and power subsystem options, please refer to the
"Options" section below.
QuickSpecs
HP ProLiant BL30p Server Blade
Configuration Information - Factory Integrated Models
DA - 11958 North America — Version 6 — September 24, 2004 Page 21