Hitachi L37A01A - Manual (Page 40)

38
FUNCTION (continued)
Power Save Mode
When the AV input is selected
You are provided the function to save power consumption when no signal is detected in AV input. Set to On in “Video
Power Save” from Function Menu, which leads to the power save mode in AV1 /AV2 /AV3 /AV4 /HDMI and the Standby
mode in other AV input. Please see the table below for details.
1. Press
button.
2. Select “Setup” menu and press button.
3. Select ”Video Power Save” and press button.
Setup
Video Power Save Off
Reset
Select ◄►On/Off Return
When no signal is detected
Condition Indicating Lamp
When signal is input during
on in “Video Power Save”
AV1~AV2
AV3~AV4
HDMI
Power Save* Orange Turns On automatically
*Power Save that only control Back Light On/Off.
Returning to operating status
● Press the Input Select button of the control panel or the remote control to restart the television.
When the RGB input is selected
When this unit is connected to a VESA DPMS computer, the Power Save mode (Operation mode: Off) can be set
to be activated automatically when the computer is not being used to reduce power consumption by this unit.
Horizontal Yes No Yes No
RGB
sync
signal
Vertical Yes Yes No No
PC signal
Active
(normal display)
Blank (no display)
Operation mode On Off
Indicating lamp Lights green Lights orange
Returning to operating status
● Operate the personal computer, then input computer’s H. sync, V. sync or press the Sub Power button of the control panel
or the remote control to restart the television.
Off
Video Power Save
On