Husqvarna 14 Pro - Manual (Page 37)

English –
35
Checking and adjustment of the throttle
wire
Check that the engine responds to the throttle
control and that the correct engine speed is
achieved at full throttle.
If in doubt, contact the service workshop
If necessary the following adjustment can be made:
1. Release the clamping screw and push the
throttle control to full throttle position.
2. Pull the throttle wire’s outer casing to the right
and tighten the clamping screw.
MAINTENANCE
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 kp/cm 2 )
all round.
To improve driving the pressure on the rear tyres
can be reduced to 40 kPa (0.4 kp/cm
2 ).
The maximum tyre pressure is 80 kPa (0,8 kp/cm 2 ).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres
will result in the blades cutting the grass
at different heights.