11 delete a tour, 12 programming sector ids, Delete a tour – Honeywell HEGS5001 User Manual
Page 44: Programming sector ids
5.2.11 Delete a Tour
1. Press
the
Dome Menu (
1. ___
3. ___
) key.
2. Press
+ or – until Tour Menu is displayed.
3. Press
Enter (
).
4. Press
+ or – until Delete is displayed.
5. Press
Enter (
).
6. Enter the desired tour # (1-3) using the numeric keys.
7. Press
Enter (
).
5.2.12 Programming Sector IDs
Sector IDs are used for labeling specific areas that the PTZ camera views. Whenever a
PTZ camera is under manual control and it is viewing a programmed sector, the name
given that sector is added to the video signal.
Note: The camera ID display must be enabled. When an operator is viewing the monitor
or a video recorder is recording a specific dome, this labeling provides a quick
reference for the area being displayed. Up to 16 Sector IDs can be programmed
for each Scan Unit.
1. Press
the
Dome Menu (
1. ___
3. ___
) key.
2. Press + or - until Sector/Priv Menu is displayed.
3. Press
Enter (
).
4. Press
+ or – until Program is displayed.
5. Press
Enter (
).
6. Enter the desired sector number (0-15) to program.
7. Press
Enter (
).
Rev. 1.01
34 900.0800
19-Jun-06