Honeywell HJZTP User Manual
Hjztp/hjztpx
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1:INTRODUCTION
- SECTION 2:INSTALLATION
- SECTION 3:SETUP
- SECTION 4:DVR CONTROL FUNCTIONS
- SECTION 5:MULTIPLEXER CONTROL FUNCTIONS
- SECTION 6:PTZ CONTROL FUNCTIONS WHEN USING HONEYWELL VCL (RAPIDDOME/ORBITER DOME) PROTOCOL
- 6.1PTZ CAMERA SELECTION CONTROL
- 6.2PTZ MODE
- 6.3PAN AND TILT
- 6.4TURN 180°
- 6.5ZOOM
- 6.6FOCUS AND IRIS
- 6.7WASH, WIPE AND AUXILIARY FUNCTIONS
- 6.8MANUAL CHANGE OVER (CHANGE OVER RAPIDDOME/ORBITER DOMES ONLY)
- 6.9PRESETS AND TOURS
- 6.9.1To Define a Preset
- 6.9.2To Seek a Preset
- 6.9.3To Start a Tour of Presets
- 6.9.4To Define a Simple Tour
- 6.9.5To Vary the Standard Speed of a Tour
- 6.9.6To Vary the Standard Speed of a Tour, Continued
- 6.9.7To Vary the Standard Speeds and Dwell Times of a Tour
- 6.9.8To Stop a Tour of Presets
- 6.9.9To Restart a Tour of Presets
- 6.10ENHANCED FUNCTIONS
- SECTION 7:PTZ CONTROL FUNCTIONS WHEN USING HONEYWELL DIAMOND (KD6/HD6) PROTOCOL
- SECTION 8:PTZ CONTROL FUNCTIONS WHEN USING HONEYWELL MAXPRO MODE (KD6/HD6) PROTOCOL
- SECTION 9:TECHNICAL SPECIFICATIONS
- APPENDIX A:MENU NAVIGATION
- APPENDIX B:DIAGNOSTICS
- APPENDIX C: VCL (ORBITER/RAPIDDOME) DATA INPUT
- APPENDIX D:PASSWORDS