Section 4: system setup, 1 setting up the controller, 2 navigating the menus – Honeywell HEGS5001 User Manual
Page 23: Setting up the controller, Navigating the menus, Mux’s [1.0] more
SECTION 4:
SYSTEM SETUP
4.1
SETTING UP THE CONTROLLER
The components controlled by the HEGS5000 are defined in the SYSTEM MENU. This
menu is available only when logged in as a Master User.
• The SYSTEM MENU is in tree structure.
• Several tools, including the LEFT () and RIGHT () keys, Enter key (
), and
the UP (
)and DOWN () functions on the joystick are used to navigate
through the menus.
• Press Enter (
) or Zoom In (clockwise) to select an option and go down one
level.
• Press Clear/Manual (
) or Zoom Out (counterclockwise) to go back one
step or up one menu level.
4.2
NAVIGATING THE MENUS
To access the System Setup, press the System Menu (
Sys
1. ___
3. ___
) key.
The LCD screen will indicate the level, menu name, and additional options.
Note: If the controller is set for
Standalone Mode, the menus start
with the Camera Menu (Level [3.0])
Using the figure, the LCD shows that
the controller is at the Multiplexer Menu, which is menu 1. More indicates that there are
more options or submenus available under this menu.
Mux’s
[1.0]
More
• To select this menu, press Enter (
).
• To move to another menu, use the joystick tilt up and tilt down functions.
Moving the joystick up will change it to menu 2, then menu 3, and so on. You
can view the menus in reverse order by moving the joystick down.
• If you have selected a menu incorrectly, press Clear/Manual (
) or “Zoom
Out” to return to the previous level.
• Once in a submenu, use the joystick or the Enter (
) key to navigate through
the available options.
Rev. 1.01
13 900.0800
19-Jun-06