Honeywell HEGS5001 - Manual (Page 32)

5.2 KD6/HD6 DOME MENUS
The HEGS5000 controller can be used to program KD6/HD6 PTZ units.
1. Press the Dome Menu (
1. ___
3. ___
) key. The following is displayed on the LCD screen.
< DOME MENU >
Dome Setup Menu
2. Press the + or – keys to scroll through the available menus. When the desired
menu is displayed, press Enter ( ) to access it.
3. To exit, press the Dome Menu (
1. ___
3. ___ ) key.
4. To exit a menu on the LCD controller, press the Clear/Manual ( ) key.
Table 2. DOME MENU (
1. ___
3. ___ ) Key – Access/Exit Dome Menus
Menu Description
Dome Setup Menu Accesses the on-screen setup menus for the KD6/HD6.
Language Selection for on-screen menus
Display Options
Control Options
Diagnostic Options
Camera Options
Function Programming (VectorScans and Tours)
PreShot Menu Accesses the KD6/HD6 PreShot menu. Use +/- keys to scroll
through menu options:
Program PreShots (0-99); PreShot 99 reserved for controlling
nightshot mode if feature available on dome camera.
List Programmed PreShots
VectorScan Menu Accesses the KD6/HD6 VectorScan menu. Use +/- keys to scroll
through menu options:
Program VectorScans (0-9)
List Programmed VectorScans
List Contents of a Specific VectorScan
Run Once
Sector/Priv Menu Accesses the KD6/HD6 Sector ID/Privacy Zone menu. Use +/-
keys to scroll through menu options:
Program Sector IDs (1-16)/Privacy Zones
List Programmed Sector IDs
Program Privacy Zones (10 – Sony camera; 2- Hitachi camera)
Rev. 1.01
22 900.0800
19-Jun-06