Hitachi VM-H39A - Manual (Page 37)

DATE/TIME SETTING
37
and then press "STOP" button.
8. Repeat step 7 to select minute and AM/PM.
9. After setting AM or PM, press "STOP" button again to erase the flashing cursor and start the
internal clock.
NOTE: The date/time graphics will be recorded whenever they appear in the viewfinder.
To record date/time graphics
Press the "DATE" button repeatedly to select the required date/time graphics in the
viewfinder, then strat recording.
• The display changes in the following order each time the "DATE" button is pressed.
NOTE: Refer to page 29 for setting the second clock.
To correct date/time after starting the date/time
1. Press and hold "DATE" button, and then press "STOP" button. The month starts
flashing.
2. Correct the incorrect digit by using "F.FWD", "REW" and "STOP" buttons.
To correct date/time during programming
1. Press "STOP" button repeatedly until the flashing cursor will be removed from the
viewfinder.
2. Follow steps 1 and 2 of "To correct date/time after starting the date/time" above.