Hitachi VM-H39A User Manual

Page 35

IDENTIFICATION AND OPERATION OF CONTROLS

Press this button to create and record personalized titles on your videos with the
camera/recorder's built-in titler. (See "TITLE RECORDING" on page 32.)

28. "REVIEW" Button
Used to review the last few seconds of the recorded segment in the record/pause mode.
29. "RESET" Button
When the linear time counter is displayed in the viewfinder, pressing this button resets
the counter to "0:00:00".
30. "DISPLAY" Button
When this button is pressed, the display in the viewfinder will change in sequence.
31. "DATE" Button
Press this button to display the date and time in the viewfinder. Whenever the date and
time appear in the viewfinder, they will be recorded on the tape.
32. "EJECT" Button
Operates with the power on or off, if a power source is connected to the
camera/recorder.

33. "

" Switch

Use to select

or normal

for recording. This switch has no effect during

playback. Normally, set it to "AUTO". "

" appears in the viewfinder when the

camera/recorder is recording or playing in

mode.

34. Grip Cover
Open this cover when attaching the battery or external power adapter.
35. "MIC" Switch
This switch is used to reduce noise that occurs due to wind. Place the switch in the
"NORM" position for normal use.
36. Tripod Mount Screw
Use this screw to mount the camera/recorder on a tripod (generally available).
37. "BATT (Battery) EJECT" Lever
Move this lever to open the grip cover when attaching the battery or external power
adapter to the camera/recorder or detaching it.
38. Camera/Recorder Control Buttons
These shaded buttons on the remote control function the same as those on the
camera/recorder.
39. "PAUSE (START/STOP)" Button
When this button is pressed during recording, the tape stops and the camera/recorder
enters the record/pause (stand-by) mode. When this button is pressed again, the tape
runs to resume recording. This button may also be used to display a still picture during
playback mode.
40. "AV DUB" Button
This button is used to record new audio and video in place of existing audio and video.