Hunter 28688 44 Stratford Five Minute Fan - Manual (Page 8)

8
42443-01 • 09/20/10 • Hunter Fan Company
WARNING: Fan may fall if not assembled as directed in these
installation instructions .
3-1 . Unbundle the wires from the fan .
For Standard or Angled mounting:
3-2 . Insert the downrod through the canopy and canopy trim ring .
Feed the wires from the fan through the downrod on one side of
the pin in the ball .
3-3 . Loosen the square head setscrew on the adapter to install the pipe
and ball assembly . Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal .
Securely retighten the setscrew with a wrench or pliers . Skip to
step 3-7 .
CAUTION: The adapter has a special coating on the threads . Do
not remove this coating; the coating prevents the downrod from
unscrewing . Once assembled, do not remove the downrod .
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the
low profile washer .
3-4 . Remove the setscrew from the adapter .
3-5 . Place the low profile washer into the canopy with the lip down .
3-6 . Align the holes in the washer with the holes in the adapter .
Assemble securely with three low profile screws .
Hanging the Fan:
Note: To hang the fan, you must tilt the canopy to an almost vertical
position so that the canopy slots sit on the ceiling plate hooks .
3-7 . Raise the fan and align the slots in the canopy with the hooks on
the ceiling plate .
3-8 . Place the slots over the hooks to hang the fan .
Steps 3-2 – 3-3
Low Profile
Washer
Downrod
Canopy
Setscrew
Low Profile Screw
Canopy
Trim Ring
Green
Ground
Wire
Standard or Angled Mounting
Low Profile Mounting
Low Profile Screws
Canopy
Canopy
Trim Ring
Adapter
Low Profile
Washer
Low Profile Screw
Steps 3-5 – 3-6
Step 3-6 (Detail)
3 • Assembling and Hanging the Fan