Hunter 28688 44 Stratford Five Minute Fan - Manual (Page 10)

10
42443-01 • 09/20/10 • Hunter Fan Company
WARNING: Failure to complete the following steps could cause the fan
to fall .
Note: It is recommended you use a magnetic tip screwdriver for the
following steps .
5-1 . Rotate the hanger ball so the tab in the canopy is secure in the
hanger ball groove . Note: Your fan may have multiple tabs and
grooves that must be aligned .
5-2 . Swing the fan up to align the canopy screw holes with the
mounting holes on the ceiling plate .
WARNING: The slots in the canopy must remain engaged while
swinging the canopy for alignment .
5-3 . Holding the canopy up with the screw holes aligned, partially
install two canopy screws into the holes opposite the ceiling plate
tabs .
5-4 . Partially install a canopy screw into the hole between the two
ceiling plate tabs .When all the holes are properly aligned, securely
tighten all three canopy screws .
5-5 . Verify that the tabs in the canopy are still in the grooves of the
hanger ball .
5-6 . Align the tabs on the trim ring opposite the grooves in the hanger
ball . Using both hands, push the canopy trim ring up to the top of
the canopy . The canopy trim ring will snap and lock into place .
Note: Should you need to remove the trim ring, press firmly on
opposite sides of the trim ring directly above the groove in the
hanger ball . The tabs will flex out releasing the canopy trim ring .
Step 5-1
Step 5-2
Groove
Tab
Step 5-3
Canopy Screw
Canopy
Trim
Ring
Canopy
5 • Installing the Canopy and Canopy Trim Ring