Henny Penny SCD-6/8 - Manual (Page 9)

Model SCD-6/8
2-10. CONTROL BOARD 1. Remove electrical power supplied to the unit.
REPLACEMENT
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the side panel closest to the controls.
3. Pull connectors from board (Figure 2-17).
Figure 2-17
4. Using 5/16” socket, remove the nuts securing the control board
and remove control board (Figure 2-18).
5. Install new board in reverse order, and restore electrical power
to unit.
Figure 2-18
Do not overtighten the nuts to the control board, or the
control decal will interfere with the buttons on the control
board.
203 2-9