Henny Penny SCD-6/8 - Manual (Page 8)

Model SCD-6/8
2-9. RELAYS (Continued)
7. Remove power supplied to unit.
8. Using a Phillips head screwdriver, remove the wires from relay
(Figure 2-15).
9. Using a Phillips head screwdriver, remove the screws securing
the relay and remove relay from unit (Figure 2-16).
Figure 2-15
10. Coat the back of the new relay with the thermal joint compound.
Failure to use the thermal joint compound will shorten
the life of the relay.
11. Install new relay and replace wires.
Figure 2-16 12. Replace side panel and restore electrical power.
2-8 203
Replacement: