Heat & Glo Fireplace 6100PLUS - Manual (Page 19)

Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05 19
Figure 8.6 Junction Box
WHT
WHT
BLK
BLK
GRN wire
inside box
Copper
ground attached
to GRN screw with
GRN wire
14/2WG
Cover Plate
outside firebox
Romex
Connector
Figure 8.5 Junction Box Detail
F. Junction Box Installation
If the box is being wired from the OUTSIDE of the appliance:
• Remove the cover plate located on the outer shell - right side (see Figure 8.5).
• Install the supplied Romex™ connector in the cover plate.
• Feed the necessary length of wire through the connector.
• Make all necessary wire connections and reattach the cover plate to the outer shell.
If the box is being wired from the INSIDE of the appliance:
• Remove the screw attaching the junction box/receptacle to the outer shell, rotate the junction box inward to disengage
it from the outer shell (see Figure 8.5).
• Pull the electrical wires from outside the appliance through this opening into the valve compartment.
• Feed the necessary length of wire through the connector.
• Make all necessary wire connections to the box/receptacle and reassemble the box/receptacle to the outer shell.