Humax NA-3712 - Manual (Page 14)

TV Rear Panel
VCR Rear Panel
From Cable/ Antenna Source
1. Connect a parabola antenna cable to the LNB IN jack.
Connect an AIR or Cable Box Antenna out terminal cable to the RF IN jack.
2. Connect between the RF OUT jack on the STB and the ANT INPUT
(RF INPUT) jack on the TV.
3. Connect a set of audio, video cables between the AUDIO, VIDEO OUT jacks on
the STB and the AUDIO, VIDEO INPUT jacks on the VCR.
• Turn on the VCR to record a program from the STB.
• When you record a STB program of a specific time, set the Wakeup Time and Service No.
of the STB Time Setting Mode to meet the starting time of the program and then do ON
• Time and Recording Time of the VCR Time Setting Mode.
(See your VCR manual for VCR ON Time and setting the Recording Time.)
• See “Connecting the Set-Top Box to your TV (using a RF CABLE).”
You can view a STB program and record it using a VCR at the same time.
Connecting the Set-Top Box to Your TV and VCR
Recording a program from STB
Viewing a program from the STB, Free-To-Air or CABLE
GB13