Humax NA-3712 - Manual (Page 12)

From Cable/ Antenna Source
TV Rear Panel
1. Connect a parabola antenna cable to the LNB IN jack.
Connect an AIR or Cable Box Antenna out terminal to the RF IN jack.
2. Connect between the RF OUT jack on the STB and the ANT INPUT
(RF INPUT) jack on the TV.
3. Turn on your STB and TV.
4. Tune the STB to VHF Channel 3 or Channel 4.
5. Tune the TV to Channel 3 or Channel 4 (same as you tune the STB).
6. Operate the STB to select a program you want to watch.
7. Switch to the STB Standby Mode.
8. Select a channel you want to watch using the TV remote control.
Connecting the Set-Top Box to Your TV (using a RF CABLE)
Viewing the STB programs
Viewing the Free-To-Air or CABLE programs
GB11