Hitachi 35UX60B - Manual (Page 44)

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
44
Click here for another picture of CLU-850GR
ANT button (35UX60B only)
Use the ANT (Antenna) button to select between the VHF/UHF and AUX (Auxiliary)
antenna inputs.
NOTE: When VHF/UHF is selected, the channel number in the upper right corner of the
screen is in green. When the AUX input is selected, the channel number is in yellow.
MENU, ENTER, CURSOR buttons
All the on-screen display features can be set or adjusted by using these buttons.
The "MENU" button will start or exit the on-screen display.
The "CURSOR" buttons will highlight functions or adjust different features.
These buttons are also used for FAVORITE CHANNELS. (See page 47.)
The "ENTER" button will set features to your preference.
"CHANNEL SELECT" buttons are used to set the time, for channel memory, etc..
CHANNEL SELECTOR buttons
Enter two or three numbers to select channels. Enter a "0" first for channels 1 to 9. Use
the "100" button for channels 100 and higher.
Channel selection may also be performed by pressing channel up (
) or down ( ).
NOTE: The TV may not receive some channels if you are not in the correct AIR/CABLE
mode. See page 44.
AVX button
The AVX (Auxiliary Video) button will select between the antenna signal and the three
sets of video input jacks each time the button is pressed. If the Picture-in-Picture (PinP)
is on, the AVX will select between the three sets of video input jacks. (See page 32.)