HP T3304 - Manual (Page 17)

Printhead
Latch Hinge
Plate Media
Guide
loading media
9 Operator’s Guide
10
If the media you are loading is of the
same width as the current media, skip
the next step and go on to step 12 .
11
If you are loading media that is of a
different width from the current media,
you may need to adjust print quality as
follows:
note
The printer is aligned at the factory with
4–mil–thick label stock, whose width is
the maximum width accepted by the
printer.
a.
Raise the hinge plate, and lower the
printhead by rotating the printhead
latch clockwise to the latched
position.
b.
Press ON LINE/PAUSE to enable
printing.
c.
Send a sample test print file from the
host, or run the internal diagnostic
test file.
note
It may be necessary to feed several
labels before proper alignment of the
media occurs.
d.
If the print quality is acceptable, go
on to step 12 .
e.
Otherwise, press ON LINE/PAUSE
again to place the printer in the off
line mode.
note
Although the head leveling knob can be
adjusted during printing, it is
recommended that this adjustment be
done while the printer is paused.