HONDA Outboard Motor BF150A - Manual (Page 46)

44
OPERATION
ON
OFF
IGNITION
SWITCH
KEY
START
CONTROL
LEVER
N (neutral)
Turn the ignition switch key to the
START position and hold it there
until the engine starts.
When the engine starts, release the
key, allowing it to return to the ON
position.
If the engine fails to start within 5
seconds, release the key and wait
at least 10 seconds before
operating the starter again.
Set the control lever in the N
(neutral) position.
The engine will not start if the F
(forward) or R (reverse) gears are
engaged.
The engine will not start or run,
unless the clip is in the switch.
The emergency stop switch clip and
lanyard system is a safety device that
will stop the engine if you fall away
from the controls while operating the
boat.
Always attach the lanyard to your
PFD, or to your wrist, before starting
the engine.
3. 2.
05/02/22 14:32:05 31ZY6600_045