HP PSC-500 User Manual
Basic operations
Table of contents
Document Outline
- Basic Operations
- HP PSC 500
- ©Copyright Hewlett-Packard Company 1999
- Note: Regulatory information can be found in Chapter 6 of the HP PSC 500 CustomerCareGuide.
- Welcome!
- All About Paper
- Printing
- 3
- Start Printing
- 1 If it is not already on, turn on the HPPSC 500 by pressing the white button located on the lef...
- 2 Load paper into the bottom (IN) tray.
- 3 Change the print settings as necessary:
- a In your program’s File menu, select Print, Print Setup, or Page Setup.
- b Make sure the printer name is set to HPPSC 500, and then select the print range and the number...
- c To change any other print settings, click Properties, Printer Setup, or Printer in your program...
- d In the Setup tab, change the Print Quality, Paper Size, and Paper Type settings as needed, and ...
- e When you are sure that the settings in the Print dialog box are correct, go to your program’s F...
- 1 If it is not already on, turn on the HPPSC 500 by pressing the white button located on the lef...
- Stop Printing
- Printing Help
- Scanning
- 4
- Using your Scanner
- Choose Your Original
- Place Your Original
- Start Scanning
- Editing Your Scanned Picture in the HP PSC Scanning Viewer
- Sending Your Scan
- 1 Click the Creative Photo Printing button.
- 1 Click the Picture to Program button.
- 2 Click OK to close the window.
- 3 Open another program or document.
- 4 Place your cursor in the location where you want your scanned picture.
- 5 Paste your scanned picture. Use the Ctrl-V shortcut or choose Paste from your program’s menu.
- 6 Close the HP PSC Scanning viewer or click New Scan to begin another scan.
- 1 Click the Text to Another Program button.
- Canceling a Scan
- Scanning Projects
- Scanning Help
- Copying
- 5
- How to Make Copies
- 1 Turn on the HPPSC 500 by pressing the white button located on the left side of the unit’s fron...
- 2 Place your original face down on the glass with the top edge along the green border. If the ori...
- 3 To change the number of copies, press the minus(–) or plus(+) button until the correct number a...
- 4 If you want to change the size of the copy, refer to the section, “Using the Reduce/Enlarge But...
- 5 Press the Copy button to make copies.
- 1 Turn on the HPPSC 500 by pressing the white button located on the left side of the unit’s fron...
- Using the Cancel Button
- Using the Paper Type Button
- Using the Select/Resume Button
- Using the Reduce/Enlarge Button
- 1 Press Reduce/Enlarge until the setting you want appears on the display.
- 1 Press Reduce/Enlarge until Clone appears, and then press Select/Resume.
- 1 Place the short side of the photo against the green strip next to the white arrow.
- CopySmart Digital Copying Features
- Copying Small Objects
- Copying Help