Hughes DIRECWAY DW4020 - Manual (Page 42)

Chapter 2 • Installing the indoor equipment
30
1031484-0001 Revision 2
Connect to customer
computer and confirm
surfing
1. Disconnect the USB cable from the installer’s PC.
2. Connect the receive modem to the Gateway using the USB
cable supplied with the unit. See Figure 31.The DW4020 will
re-initialize and come back up in normal mode.
3. Connect the receive coaxial cable to the receive modem and
the transmit coaxial cable to the transmit modem. See
Figure 31.
4. Plug the power cord into the wall outlet or surge protector.
5. Make sure that the READY LEDs on all three units are
STEADY GREEN. Make sure the transmit and receive cables
are clearly labeled at the connectors.
6. The DW4020 is now commissioned. Connect the customer’s
computer and the Gateway with Ethernet cable. See
Figure 31. If the computer has a functioning and properly
configured Ethernet interface, it will surf the Internet. If the
customer cannot surf, see the instructions below.
Figure 30: ACP passes; select Exit