HP Photosmart E317 - Manual (Page 17)

17 Getting Started
7. Install the Software
The HP Image Zone software allows you to transfer images.
NOTE: If you do not install the HP Image Zone software, you
can still transfer images. For details, see Using Your
Camera without Installing the HP Image Zone Software
on page 77.
NOTE: If you have trouble installing or using the HP Image
Zone software, see the HP Customer Support website:
www.hp.com/support for more information.
Windows®
To install the HP Image Zone software successfully, your
computer must have a minimum of 64MB of RAM, Windows
2000, XP, 98, 98 SE, or Me, and Internet Explorer 5.5
Service Pack 2 or higher. Internet Explorer 6 is
recommended. If your computer meets these requirements,
the installation process installs either the full version of
HP Image Zone or HP Image Zone Express. For differences
between these, see HP Image Zone Software on page 75
and HP Image Zone Express (Windows Only) on page 76.
1. Close all programs and temporarily disable any virus
protection software running on your computer.
2. Insert the HP Image Zone software CD into the CD drive
of your computer and follow the on-screen instructions. If
the installation screen does not appear, click Start, click
Run, type D:\Setup.exe, where D is the letter of your CD
drive, then click OK.
3. When the HP Image Zone software has finished
installing, re-enable the virus protection software you
disabled in Step 1.