Hoshizaki STACKABLE CRESCENT CUBER KM-2000SRH3 User Manual

Page 27

20) Remove the Front Panel, and fully open the Cleaning Valve.

21) Move the Control Switch to the “WASH” position.

22) Replace the Front Panel in its correct position.

23) Turn on the power supply to rinse off the cleaning solution.

24) Turn off the power supply after 5 minutes.

25) Remove the Front Panel and the Insulation Panel.

26) Remove the Cap located on the front bottom part of the Ice Dropping Hole. Drain the

Water Tank. Replace the Cap and the Insulation Panel in their correct position.

Note: Do not replace the Insulation Panel when you proceed to “[b] SANITIZING

PROCEDURE.”

27) Repeat the above steps 15) through 26) three more times to rinse thoroughly.

Note: If you do not sanitize the icemaker, go to the step 9) in “[b] SANITIZING

PROCEDURE.”

[b] SANITIZING PROCEDURE - Following Cleaning Procedure

1) Dilute a 5.25% Sodium Hypochlorite solution (chlorine bleach) with water
(Add 3.5 fl. oz. of sanitizer to 7 gal. of water).

2) Pour the sanitizing solution into the Water Tank.

3) Replace the Insulation Panel and the Front Panel in their correct position.

Note: Make sure that the Control Switch is in the “WASH” position and the Cleaning

Valve is open.

4) Turn on the power supply, and start the sanitizing process.

5) Turn off the power supply after 15 minutes.

6) Remove the Front Panel and the Insulation Panel.

7) Remove the Cap located on the front bottom part of the Ice Dropping Hole. Drain the

Water Tank. Replace the Cap and the Insulation Panel in their correct positions.

8) Repeat the above steps 15) through 26) in “[a] CLEANING PROCEDURE” two times to
rinse thoroughly.

This manual is related to the following products: