Hoshizaki STACKABLE CRESCENT CUBER KM-2000SRH3 - Manual (Page 12)

12
4) Remove the panels of the second icemaker.
5) Stack the upper unit on the top of the lower unit.
6) Secure the upper unit to the lower unit by using the two Universal Braces and the four
bolts provided.
7) Remove the Thermostat Bulb Attachment of the upper unit from the Thermostat
Bracket.
8) Route the Bin Control Thermostat Capillary Tubing of the upper unit through the bottom
hole of the upper unit and the Thermostat Bracket of the lower unit. Secure the
Thermostat Bulb of the upper unit to the Thermostat Bulb Attachment of the lower unit
with the Thermostat Bulb Attachment and the screws of the upper unit.
6) Level the icemaker/Storage Bin in both the left-to-right and front-to-rear directions.
Adjust the Ice Bin Legs to make the icemaker level.
7) Place the panels in position.
5. INSTALLATION OF THE SECOND UNIT - See Figures 4 and 5 5. INSTALLATION OF THE SECOND UNIT - See Figures 4 and 5 5. INSTALLATION OF THE SECOND UNIT - See Figures 4 and 5 5. INSTALLATION OF THE SECOND UNIT - See Figures 4 and 5 5. INSTALLATION OF THE SECOND UNIT - See Figures 4 and 5
1) See “4. SET UP” for the lower unit installation.
2) Remove the Top Panel and the Top Insulation of the lower unit. The Top Panel and the
Top Insulation of the lower unit are not required when installing the second icemaker.
3) Unpack the second icemaker (upper unit), and remove all shipping cartons, tape(s) and
packing.
Fig. 4 Fig. 4 Fig. 4 Fig. 4 Fig. 4