Loading coil nails – Harbor Freight Tools CENTRAL PNEUMATIC 93257 User Manual

Page 7

Connect the air supply to the tool at the Air Plug (82-not included). Set the regu-

lator at the recommended 70 to 125 operating PSI. Do not exceed the maximum

125 PSI.

Test the tool by depressing the Safety (38) against a piece of scrap wood without

pulling the Trigger (60). The tool must not cycle (fire). If it cycles (fires), stop im-

mediately and have it repaired by a qualified service technician.

(See Figure B.)

Hold the tool away or off the workpiece. The Safety (38) of the tool should return

to its original position. Squeeze the Trigger (60). The tool should not cycle (fire).

If the tool cycles (fires), stop immediately and have it repaired by a qualified ser-

vice technician. (See Figure B.)

Depress the Safety (38) against the workpiece and squeeze the Trigger (60). The

tool must cycle (fire) only once. Release the Trigger and squeeze it again. The

tool must not cycle (fire). With the Trigger held, carefully lift the Nailer and press it

against the scrap wood again. The tool must not cycle (fire). If it fails to perform

in the manner explained in bold, have it repaired by a qualified service technician.

(See Figure B.)

SKU 93257 For technical questions, please call 1-800-444-3353 PAGE 7

LATCH

(57)

DOOR

(32)

MAGAZINE COVER

(91)

FIGURE C

LOADING COIL NAILS

WARNING: Always wear ANSI approved impact safety goggles when re-

loading or performing any other maintenance on this tool. Other people in the

work area must also wear ANSI approved impact safety goggles.

WARNING! Make sure the Nailer is not attached to the air hose when

loading the tool.

To open the Magazine Cover (91), press down on the Latch (57) and swing the

Door (32) open. Then, swing the Magazine Cover open. (See Figure C.)

Rev 06k; REV 06l