Harbor Freight Tools CENTRAL PNEUMATIC 93257 - Manual (Page 4)

SKU 93257 For technical questions, please call 1-800-444-3353 PAGE 4
15. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
16. Replacement parts and accessories. This product is to be repaired and
serviced only by a qualified technician. When this product is serviced, only
identical replacement parts should be used. Use of any other parts will void the
warranty. Only use accessories intended for use with this tool. Approved
accessories are available from Harbor Freight Tools.
17. Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgement or reflexes
are impaired while taking drugs. If there is any doubt, do not operate the tool.
18. Use proper size and type extension cord. If an extension cord is required, it must
be of the proper size and type to supply the correct current to the compressor
without heating up. Otherwise, the extension cord could melt and catch fire, or
cause electrical damage to the tool. Check your air compressor’s manual for the
appropriate size cord. It is also possible that the use of an extension cord may
cause your circuit breaker to trip or your panel fuse to break. If this happens, ei-
ther use a longer air hose, use the compressor without an extension cord, or find
a larger amperage circuit to use.
19. Maintenance. The maintenance outlined in the “Maintenance” section should be
performed regularly. For your safety, this product should be serviced or repaired
regularly only by a qualified technician.
20. Compressed air only. Never use combustible gas as a power source.
21. Do not load nails with the trigger or safety depressed. Unintentional firing
may occur. Do not load nails when the air hose is connected to the tool.
Always assume the tool contains nails.
22. Disconnect air supply before loading the Nailer. Before reloading (or making
any adjustments to) the Nailer, make sure the compressed air is disconnected.
23. Fire nails into an appropriate work surface only. Do not attempt to fire nails
into surfaces too hard to penetrate. Do not drive nails on top of other nails, or at
too steep an angle. Nails can ricochet, causing personal injury. Never fire the
Nailer into the air, or point it toward yourself or another person. Always wear
ANSI-approved impact safety goggles during use, maintenance, and reloading.
24. Do not fire nails too close to the edge of a workpiece. They may split the
workpiece and fly free, causing personal injury.