Harbor Freight Tools CENTRAL PNEUMATIC 93257 - Manual (Page 10)

SKU 93257 For technical questions, please call 1-800-444-3353 PAGE 10
CLEARING JAMS
1. Occasionally, a Nail may become jammed in the firing mechanism of the Nailer,
making the tool inoperable.
2. To remove a jammed Nail, disconnect the Nailer from its air supply. Empty the
Magazine (85) completely of Nails. Attempt to fire the Nailer into a piece of scrap
wood to ensure it is disconnected and is incapable of firing any Nails.
3. Use a pair of needle nose pliers to remove the jammed Nail (usually in the Feed
Pawl (42) area.
4. Replace the coil of nails into the Nailer. Close the Magazine Cover (91) and Door
(32) securely. Then, reconnect the air supply hose to the Nailer.
5. Press the Safety (38) against a piece of scrap wood, and test fire the Nailer
several times while checking for proper operation. If the Nailer is properly firing,
you may continue using the tool. If the tool fails to perform properly, immediately
discontinue use and have the tool repaired by a qualified service technician.
6. When finished working, disconnect the air supply. Remove the nails. Then, store
the Nailer in a clean, dry, safe location out of reach of children.
Anytime any maintenance or repairs are done (including clearing jams), FIRST:
1. Disconnect the Nailer from its air supply.
2. Empty the Magazine (85) completely.
3. Attempt to fire the Nailer into a piece of scrap wood to ensure that it is disconnected
and is incapable of firing any Nails.