Troubleshooting, Call us first, Problem possible cause solution – Homelite UT10582 User Manual
Page 39
Page 39 — English
TROUBLESHOOTING
Problem
Possible Cause
Solution
Engine starts, runs,
and accelerates
but will not idle.
Chain tur ns at
idle.
Carburetor requires
adjustment to idle
speed.
Carburetor requires
adjustment to idle
speed.
Air leak in the intake
system.
Turn idle speed screw
“T” clockwise to increase idle
speed. Refer to
Adjusting the Carburetor in the
Maintenance section of this manual.
Turn idle speed screw
“T” counterclockwise to de-
crease speed. Refer to
Adjusting the Carburetor in
the Maintenance section of this manual.
Contact an authorized service center for a rebuild kit.
B a r a n d c h a i n
running hot and
smoking.
Chain oil tank empty.
Chain tension is too
tight.
Oiler is not
functioning.
Oil tank should be filled every time fuel tank is filled.
Tension chain per instructions in
Adjusting the Chain
Tension in the Maintenance section of this manual.
Run at half throttle 30 to 45 seconds. Stop saw and
check for lubricant dripping from SAFE-T-TIP
®
and guide
bar. If lubricant is present, the chain may be dull or bar
may be damaged. If no lubricant is on the SAFE-T-TIP
®
,
contact an authorized service center.
Engine starts and
runs, but chain is
not rotating.
Chain brake is
engaged.
Chain tension is too
tight.
Guide bar and
chain assembled
incorrectly.
Guide bar and/or
chain are damaged.
Drive sprocket teeth
damaged
Release chain brake. Refer to
Operating the Chain
Brake in the Operation section of this manual.
Tension chain per instructions in
Adjusting the Chain
Tension in the Maintenance section of this manual.
Refer to
Replacing the Guide Bar and Chain in the
Maintenance section of this manual.
Inspect guide bar and chain for damage.
Contact an authorized service center for drive sprocket
replacement.
Chain tensioning
dial is difficult to
turn.
Tip of guide bar is not
raised.
Clutch cover lock
knob is too tight.
Raise tip of guide bar while rotating tension adjustment
dial.
Press in the clutch cover lock knob and rotate coun-
terclockwise to slightly loosen the clutch cover before
attempting to adjust chain tension.
CALL
1-800-242-4672
www.h
omelite
.com
Call uS FirSt
For any questions about operating or maintaining your product,
call the Homelite
®
Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.