Maintenance, Bar and chain combinations – Homelite UT10582 User Manual
Page 37
Page 37 — English
MAINTENANCE
STORING THE PRODUCT
Clean all foreign material from the product. Store
it in a well-ventilated place that is inaccessible
to children. Keep away from corrosive agents
such as garden chemicals and de-icing salts.
Abide by all Federal and local regulations for
the safe storage and handling of gasoline.
When storing 1 month or longer:
Drain all fuel from tank into a container approved
for gasoline.
Run the engine until it stops. This will remove
all fuel-lubricant mix that could become stale
and leave varnish and gum in the fuel system.
Squeeze primer bulb several times to purge fuel
from carburetor.
Drain all bar and chain lubricant from tank into
a container approved for oil.
Always place the scabbard over the guide bar
and chain before transporting or storing the
unit.
BAR AND CHAIN COMBINATIONS
Chain specifications: 3/8 in. pitch, .05 in. chain gauge
Length of Bar
Guide Bar Part Number
Chain Part Number
Drive Links
14 in.
310625001
901212001
52
16 in.
310626001
901212002
56
18 in.
310627001
671258001
62
HIGH ALTITUDE ENGINE OPERATION
Please have an authorized service center adjust
this engine if it is to be run above 2000 feet. Failure
to do so may result in poor engine performance,
spark plug fouling, hard starting, and increased
emissions. Carburetor adjustment by an authorized
service center will improve performance and allow
that this engine meets EPA (Environmental Protec-
tion Agency) and California ARB (Air Resources
Board) emission standards. An engine adjusted
for high altitudes can not be run at 2000 feet or
lower. In doing so, the engine will overheat and
cause serious engine damage. Please have an
authorized service center restore high altitude
modified engines to the original factory specifica-
tion before operating below 2000 feet.