Hitachi 26LD9000TA - Manual (Page 37)

37
ENGLISH
TROUBLESHOOTING(continued)
Symptom and Check List (continued)
Symptoms Check list Page
z No picture
The Indicating lamp ĺ Off
z Check if the Power Cord is plugged into the socket firmly.
z Check if the Main Power is ON.
14
,
19
z No picture
The Indicating lamp ĺ Orange
It means that the unit is in “Power Save
mode”.
z Check if all the cables of the external equipments are connected
correctly and firmly.
z Check if the power of the external equipments is ON.
z Check if the TV/AV mode has been selected correctly.
z Check if the PC is in Power Save mode or not.
z Refer to “Power Save mode” and “When following messages appears
on the screen”
35
z No picture
The indicating lamp ĺ Green
z Check if the signal cable is connected correctly and firmly.
z Adjust the level of Brightness and Contrast lower.
14
~ 18
z The top of the television and surface of
the panel heat up.
z It may happen when you use the unit for long hours. Turn off the Main
Power of the unit for a while. Please note that this is not malfunction.
39
,
41
z Image cannot be displayed in the correct
position.
z Press button to check if the input signal of the displayed image is
compatible with the specification of the television.
25
,
39
,
41
z When the VCR is in special playback
features (Fast forward or Rewind), the
screen gets dark and cannot see the
image at all.
z It could happen when the VCR is connected to Component output,
such as 480i. This is not malfunction.
z Try Composite output or S-video output and check the picture again.
z Screen display size cannot be switched
correctly.
z The display size is fixed at “Full” when the receiving signals are
1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.
z Check the signal status by pressing the button on the remote
control.
32
, 33
z Cannot be displayed the image from HDMI.
z Check if the cables are connected correctly.
z Check the output format of the equipments.
z (Please refer to “Connecting Procedure” and “Recommended Signal
List”.)
40
~ 41