Hitachi 26LD9000TA - Manual (Page 21)

21
ENGLISH
BASIC OPERATION (continued)
Input Switching to TV/AV1~4, HDMI, and RGB
By pressing Input Select button, you can switch the input.
Ɣ To watch actual broadcast, press Input Select button on the control
panel, the numeric buttons or Channel Up / Down button on the
remote control.
Ɣ To display the image outputting from the external equipments
connected to each terminal (AV1~4, HDMI and RGB), select
corresponding mode.
1. Press Input Select buttons on the remote control.
2.The Input modes can be also switched by using Input Select button
on the control panel.
Each time this button is pressed, the screen displays corresponding
mode by following order.
TV AV1 AV2 AV3
AV4 RGB HDMI
3. To directly go back to TV mode, pressing channel Up/Down buttons
on remote control or pressing Program UP/Down on the control
panel.
Also, you can use the numeric buttons on the remote control.
Program Up
button Program Down
button
Input Select
Input Signal Screen Display
The input signal status can be displayed on the screen by pressing the
button of the remote control.
• The display will go out in approximately 5 seconds.
TV
1
ABCDE
ź
TV position
Name
Sound mode
VIDEO
Input mode
Signal mode
AV1
Composite
RGB
RGB
H: 48.4 kHz
V: 60.1 Hz Input vertical frequency of RGB
Input horizontal frequency of
Input Mode
`
RECALL
button
Input Select
buttons
Channel
UP/DOWN
buttons