Hitachi 26LD9000TA - Manual (Page 34)

34
FUNCTION (continued)
Audio Switching
Sound Multiplex (TV mode)
You can make optimum use of available audio by pressing bottom of remote control. Audio can be switched only if
receiving sound multiplex signals; otherwise, pressing this button will have no effect, such as when only mono sound is
received.
These can be divided into two main categories: Bilingual/Dual Sound broadcast and Stereo broadcast.
Bilingual/Dual Sound broadcast
Bilingual broadcast is the broadcast available on the main and sub languages, while dual sound broadcast is available on
the primary and secondary sounds; for example, some sports programs contain broadcast commentary on a game as
primary sound, and a commentary about a team as the secondary.
When bilingual program is received, sound mode display appears in yellow as shown.
Each time button is pressed, the display is switched in the sequence of following.
Green Yellow
Yellow
ˮ˜˰ ˮ˜˜˰ ϰ
[I]…Main language/Primary Sound
[II]...Sub language/Secondary Sound
ź…force mono: This selects main language or primary sound.
Stereo broadcast
With stereo broadcast, you can enjoy different sound from either side.
When a stereo program is received, sound mode display will appear in red as shown.
Press button to switch between stereo and mono sound.
Green Red ϰʳ
NOTE
z
Please select ź (force mono) in case of poor reception, noise, poor stereo sound due to signal condition so that you
can receive a clear mono sound.
z
ϯrepresents the Mono broadcast.
…Stereo
ϰ…...Force Mono
Sound multiplex signal
Sound multiplex signal