Hunter Fan 44110 User Manual

Page 41

2. Span setting mode – allows you to adjust the system ON/OFF

cycle rate. The default setting is 2 (the system cycles ON or

OFF when the temperature is within 1

F (0.5

C) above and

below the set temperature). The span setting can be adjusted

if your system is cycling too fast or too slowly.

Press and hold both the

and

Down

buttons until the word

SPAN appears. Use the

Down

button to adjust the span

setting.

(Up will increase your cycle time by allowing the system to run longer;

down will decrease your cycle time by causing the system to run for a
shorter length of time.)

Span settings remain the same for

HEAT

and

COOL

system

settings. When batteries are installed, or the unit is

RESET

, the

span cycle will revert to 2.

icons anD features, cont.