Hunter Fan 44110 User Manual
Page 17
installing the thermostat, cont.
CONNECTING THE WIRES
1. Loosen, but do not remove, the terminal screws.
note: a jumper wire has been provided, connecting
the rc and rh terminals for systems that do not
provide both an rh and rc wire. if you have both an
rh and rc wire, remove this jumper. if you do not
have both an rh and rc wire, leave the jumper in
place.
2. Match and connect the wires from the wall to the terminals
as shown. Wires should be inserted behind the black terminal
shields. Tighten each screw after the connection has been
made.
(the ends of any extra wires should be individually wrapped in
electrical tape and carefully pushed back into the wall.)
3. Push any excess wire length back into the wall to prevent
interference.
G RC RH Y W
Jumper
17
- 44272 (2 pages)
- 47110A (2 pages)
- 47350A (23 pages)
- 44428 (22 pages)
- 40170 (33 pages)
- 47250A (7 pages)
- 44132 (2 pages)
- 42122 (25 pages)
- 44033-01 44277 (37 pages)
- 43154 (7 pages)
- SET & SAVE 44155C (52 pages)
- 44550 (38 pages)
- 40135 (30 pages)
- 43168 (21 pages)
- 44377W (64 pages)
- 44905 (54 pages)
- 42999 44050S (23 pages)
- 42710-01 (58 pages)
- 44050 (24 pages)
- 44008-01 (100 pages)
- 144860 (76 pages)
- 43255 (7 pages)
- 47550 (38 pages)
- 44660 (2 pages)
- 44377 (45 pages)
- 43057 (13 pages)
- 44459 (40 pages)
- PH20-30A (26 pages)
- 44665 (2 pages)
- 43157 (2 pages)
- 42711-01 (55 pages)
- 47300A (44 pages)
- 44760 (28 pages)
- 44127 (37 pages)
- 44260 (104 pages)
- 43665 (49 pages)
- 43355 (43 pages)
- 47200A (7 pages)
- 43153 (2 pages)
- 40120 (28 pages)